![]() ![]() The messages express the views of the author of the message, not necessarily Or usefulness of any message, and are not responsible for the contents of any If you had QL you wouldn't need the wood, I select OR2 & then just scoot under & do the filters!ĪJOR does not vouch for or warrant the accuracy, completeness The quarry just out of town gave me $50 for the fuel but i know the owner and they will use it in their loader to stop the flow pull the cable tie out.Īll very easy and you could do it in petrol station car park if you had to push the cable tie through the check valve and quickly get the hose in the jerry with the end of the cable tie hanging out I have a lift kit and the hose length and clearance under the car was perfect to get a red Willow 20lt jerry under there position the hose inside the spout with enough wiggle room to still be able to push the cable tie further down the hose to put pressure on the check valve. lay the jerry down on its long edge with the cap up ![]() put the large cable tie down the tube until you hit the check valve and STOP! disconnect the rubber hose from the fuel neck be prepared to get a little diesel on your arm Put some rags down, or not I just plan to hit it with a pressure cleaner and degreaser loosen the two hose clamps on the hose that connects the fuel neck to the gas tank under the passenger side rear door Stack the blocks of wood and drive the car forward and up to raise the front We are also going to trade it in the next 6 months and my conscious got the better of me.Ģ blocks of wood (ramps, jack and stands alternative) Well I had this morning off and after crawling under the GC I told myself it was going to be easy and that it would be silly not to not drain it. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |